Setting the optical port mode of Huijue switch

Optical ports on Huijue switches can be configured for data transmission, LLDP proxy, and interface splitting using system view commands and proper transceiver handling.Basic Optical Port ConfigurationTo configure an optical port on a Huijue switch, first access the system view via the console or management interface. Use the following steps:Enter the interface view for the optical port:CodeCopysystem-viewinterface 10GE1/0/1 Enable LLDP if the port will act as a proxy for PoE negotiation:CodeCopypoe lldp-proxy This is required when using a hybrid optical/electrical cable to provide PoE to an AP while the electrical port remains down . LLDP must be enabled on the optical port for negotiation.Enable PoE++ compatibility if needed:CodeCopypoe legacy enable This ensures the optical port can check compatibility for devices requiring higher PoE power .Interface Split and MergeFor high-bandwidth interfaces, such as 40GE ports, you can split the interface into multiple 10GE interfaces:Split a 40GE interface:CodeCopyport split dimension interface 40GE1/20/1 The converted interfaces are numbered sequentially, e.g., 40GE1/20/1:1 to 40GE1/20/1:4 .Restart the switch after splitting to bring the converted interfaces up. The original configuration on the interface will be lost, so save the configuration before performing a rollback if needed.Stack considerations: If the split interface is part of a stack, the configuration is automatically delivered to new stack members, but the startup time may be longer .Transceiver and Fiber HandlingAlways install transceivers before connecting fiber-optic cables to prevent damage .Remove cables before removing transceivers.Use an ESD-preventative wrist strap when handling transceivers.Keep connectors and fiber ends clean and dust-free to maintain signal quality and prevent attenuation above 0.35 dB .Saving and Committing ConfigurationAfter configuring the optical port or performing interface splits:Save the configuration:CodeCopysave Restart the switch if required for the changes to take effect .SummaryLLDP proxy: Use poe lldp-proxy for hybrid cables.PoE++ support: Enable with poe legacy enable.Interface split: Use port split dimension interface for high-bandwidth ports.Transceiver care: Install before fiber, keep clean, and use ESD protection.Commit changes: Save configuration and restart if necessary. These steps ensure the optical port is properly configured for data transmission, PoE negotiation, and flexible interface management on Huijue switches .